Exemples d'utilisation de "mounting" en anglais avec la traduction "крепления"

<>
2/Tilt angle, height difference with a seat mounting, surface texture, etc. 2 Угол наклона, разница в высоте крепления сиденья, текстура поверхности и т.д.
Analysis of the metallurgic defects and of the test-pieces structure taken from the hub mounting area and in the disc to rim transition area or in the failure zone if any. анализ металлургических дефектов и структуры испытательных образцов, отобранных из зоны крепления колеса к ступице, и из зоны сочленения диска с ободом или из зоны поломки, если таковая имеет место.
Check of the mechanical characteristics (Rp0,2, Rm, and A) of test-pieces taken from the hub mounting area and in the disc to rim transition area or in the failure zone if any. проверка механических характеристик (Rp0,2, Rm и А) испытательных образцов, отобранных из зоны крепления колеса к ступице, и из зоны сочленения диска с ободом или из зоны поломки, если таковая имеет место;
The mounting strip and barrier flange holes may be widened from 9.5 mm up to a maximum of 25 mm in order to accommodate differences in back-plate arrangements and/or load cell wall hole configurations. Отверстия в монтажной полосе и фланцах барьера могут быть увеличены с 9,5 мм до максимум 25 мм для устранения расхождений с компоновкой задней плиты и/или для обеспечения соответствия конфигурации отверстий, предназначенных для крепления датчика нагрузки.
Each cell or battery is subjected to three shocks in the positive direction followed by three shocks in the negative direction of each of three mutually perpendicular mounting positions of the cell for a total of 18 shocks. Каждый элемент или каждая батарея подвергается трем ударам в положительном направлении, а затем трем ударам в отрицательном направлении, наносимым в каждом из трех взаимно перпендикулярных положений крепления элемента или батареи, т.е. в общей сложности подвергается 18 ударам.
Each cell or battery shall be subjected to three shocks in the positive direction followed by three shocks in the negative direction of three mutually perpendicular mounting positions of the cell or battery for a total of 18 shocks. Каждый элемент или каждая батарея подвергается трем ударам в положительном направлении, а затем трем ударам в отрицательном направлении, наносимым в каждом из трех взаимно перпендикулярных положений крепления элемента или батареи, т.е. в общей сложности подвергается 18 ударам.
Wheel fixing tightening torque; drawing attention to the importance of this aspect and the need to preferably use a calibrated torque wrench; Instruction regarding the necessity to re-tighten the wheel fixing after 50 km of driving; References to the use and mounting of hubcaps, if applicable; крутящий момент затяжки креплений колеса; акцентирование важности этого аспекта и предпочтительности использования калиброванного гаечного ключа с ограничением по крутящему моменту; инструкция относительно необходимости дополнительной затяжки крепления колеса после 50 км пробега; указания относительно использования и монтажа декоративных колпаков, если это применимо.
Acceleration transducers in particular should be mounted in such a way that the initial angle of the real measurement axis to the corresponding axis of the reference axis system is not greater than 5°unless an analytical or experimental assessment of the effect of the mounting on the collected data is made. Преобразователи ускорения должны, в частности, крепиться таким образом, чтобы начальный угол фактической оси измерения и соответствующей оси контрольной системы не превышал 5°, за исключением тех случаев, когда известна аналитическая или экспериментальная оценка влияния крепления на результаты измерения.
The mass of the foam and the rubber skin together shall be 0.6 + 0.1 kg (this excludes any reinforcement, mountings, etc. which are used to attach the rear edges of the rubber skin to the rear member). Общая масса пенопласта и кожи из резины должна составлять 0,6 + 0,1 кг (за исключением любых элементов усиления, крепежных деталей и т.п., которые используются для крепления задних краев резинового листа, имитирующего кожу, к задней части).
Les exemples sont fournis uniquement à des fins linguistiques, c'est-à-dire pour étudier l'utilisation de mots dans une langue et leurs traductions dans une autre. Ils sont extraits automatiquement des sources ouvertes en utilisant des algorithmes de recherche de données bilingues. Si vous trouvez une erreur d'orthographe, de ponctuation ou autre soit dans l'original ou dans la traduction, utilisez l'option "Signaler un problème" ou écrivez-nous.

Dans cette section, vous pouvez voir comment les mots et les expressions sont utilisés dans différents contextes à l'aide d'exemples de traductions faites par des professionnels. La section Contextes vous aidera à apprendre l'anglais, l'allemand, l'espagnol et d'autres langues. Vous trouverez ici des exemples de verbes à particule et d'expressions idiomatiques dans des textes dont le style et le thème varient. Les exemples peuvent être triés par traductions et domaines thématiques.

Apprenez des langues étrangères, découvrez les traductions de millions de mots et d'expressions avec des exemples réels de leur utilisation grâce à notre technologie de recherche bilingue !