Sentence examples of "engine speeds" in English with translation "оборот двигателя"

<>
Higher engine speeds are permitted in any cycle phase. Повышенные обороты двигателя допускаются на любой фазе испытательного цикла.
The engine speeds A, B and C must be calculated as follows: Числа оборотов двигателя A, B и C рассчитываются следующим образом:
Table 18: Correlation between normalised max engine speeds for upshifts and power to mass ratio Рисунок 18: Корреляция между нормированными значениями максимальных оборотов двигателя при переключении на повышенную передачу и отношением мощности к массе
The engine speeds A, B and C may be verified by either of the following methods: Числа оборотов двигателя A, B и C можно проверить с помощью одного из нижеперечисленных методов:
The engine speeds A, B and C must be declared by the manufacturer in accordance with the following provisions: Числа оборотов двигателя A, B и C должны быть указаны заводом-изготовителем в соответствии с изложенными ниже положениями.
These alternate techniques must satisfy the intent of the specified mapping procedures to determine the maximum available torque at all engine speeds achieved during the test cycles. Эти альтернативные методы должны отвечать цели конкретных процедур отображения для определения максимального крутящего момента при всех оборотах двигателя, достигаемых в ходе циклов испытания.
The maximum power, nhi and nlo must be determined from this mapping curve, and engine speeds A, B and C must be calculated according to the above provisions. Максимальная мощность, nhi и nlo должны определяться с помощью такой кривой отображения, а числа оборотов двигателя A, B и C- рассчитываться в соответствии с вышеизложенными положениями.
The maximum power, nhi and nlo must be determined from the power curve, and engine speeds A, B and C must be calculated according to the above provisions. Максимальная мощность, nhi и nlo должны определяться с помощью кривой мощности, а числа оборотов двигателя A, B и C- рассчитываться в соответствии с вышеизложенными положениями.
The test consists of a sequence of three load steps at each of the three engine speeds A (cycle 1), B (cycle 2) and C (cycle 3) determined in accordance with annex 4, paragraph 1.1., followed by cycle 4 at a speed within the control area and a load between 10 per cent and 100 per cent, selected by the Technical Service 1. Испытание состоит из серии трех шагов нагрузки при каждом из трех чисел оборотов двигателя А (цикл 1), В (цикл 2) и С (цикл 3), определенных в соответствии с пунктом 1.1 приложения 4, за которыми следует цикл 4 при числе оборотов в пределах контрольной зоны и при нагрузке в пределах от 10 % до 100 % по выбору технической службы1.
n is the engine speed in min-1, n- число оборотов двигателя в мин-1,
s is the rated engine speed in min-1, s- номинальное число оборотов двигателя в мин-1,
the engine speed during the test, including any tolerances, число оборотов двигателя в ходе испытания, включая любые допуски,
Engine speed for vehicles with automatic gearbox (1 Hz resolution), количество оборотов двигателя для транспортных средств с автоматической коробкой передач (разрешение 1 Гц);
Ratio 1 = primary ratio (ratio of engine speed to rotational speed of primary gearbox shaft). Передаточное число 1 = первичное передаточное число (отношение числа оборотов двигателя к скорости вращения ведущего вала коробки передач).
" per cent load " means the fraction of the maximum available torque at an engine speed. " процент нагрузки " означает соответствующую долю максимального полезного крутящего момента при данном числе оборотов двигателя.
npref is the engine speed where the max. torque integral is 51 per cent of the whole integral npref- число оборотов двигателя, при которых максимальный интеграл крутящего момента составляет 51 % от полного интеграла
Engine speed and torque command set points must be issued at 5 Hz (10 Hz recommended) or greater. Сигналы регулирования числа оборотов двигателя и крутящего момента должны подаваться через 5 Гц (рекомендуется 10 Гц) или более.
ndvi is the ratio between engine speed in km/h and vehicle speed in min-1 in gear i. ndvi- коэффициент, отражающий соотношение между числом оборотов двигателя в мин-1 и скоростью транспортного средства в км/ч на передаче i.
ndvi is the ratio between engine speed in min-1 and vehicle speed in km/h in gear i. ndvi- коэффициент, отражающий соотношение между числом оборотов двигателя в мин-1 и скоростью транспортного средства в км/ч на передаче i.
ndv1 is the ratio between engine speed in min-1 and vehicle speed in km/h in gear 1. ndvi- коэффициент, отражающий соотношение между числом оборотов двигателя в мин-1 и скоростью транспортного средства в км/ч на передаче 1.
Examples of word usage in different contexts are provided solely for linguistic purposes, i.e. to study word usage in a sentence in one language and how they can be translated into another. All samples are automatically collected from a variety of publicly available open sources using bilingual search technologies.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.

In this section, you can see how words and expressions are used in different contexts using examples of translations made by professionals. The Contexts section will help you learn English, German, Spanish and other languages. Here you can find examples with phrasal verbs and idioms in texts that vary in style and theme. Examples can be sorted by translations and topics.

Learn foreign languages, see the translation of millions of words and expressions, and use them in your e-mail communication.