Sentence examples of "test pieces" in English
1/These test pieces can be taken from one container
1/Эти испытываемые детали могут быть взяты из одного баллона.
Maintain the temperature of the test pieces at 45 ± 5°C throughout the test.
Температура образца поддерживается в пределах 45 ± 5°С на протяжении всего испытания.
Ten test pieces shall be tested at a temperature of + 40 ± 2°C and ten at a temperature of- 20 ± 2°C.
Десять испытываемых элементов подвергаются испытанию при температуре + 40 ± 2°C, а другие десять испытываемых элементов ? при температуре- 20 ± 2°C.
Test pieces from containers with one circumferential weld only (two sections) shall be taken from the places shown in appendix 2, Figure 1.
Испытываемые детали баллонов, имеющие лишь один периферийный сварной шов (двухсекционные), должны быть взяты из тех мест, которые указаны на рис. 1 в добавлении 2.
Test pieces from containers with longitudinal and circumferential welds (three or more sections) shall be taken from the places shown in appendix 2, Figure 2.
Испытываемые детали баллонов с продольными и периферийными сварными швами (по крайней мере, трехсекционные) должны быть взяты из тех мест, которые указаны на рис. 2 в добавлении 2.
Maintain this temperature for a period of two hours, then allow the test pieces to cool to the temperature specified in paragraph 6.1.1.
Эта температура поддерживается в течение двух часов, затем испытательные элементы охлаждаются до температуры, указанной в пункте 6.1.1.
The impact test pieces shall be taken in the direction as required in table 6.2 of Annex 3 from the wall of the cylinder.
Образцы, предназначенные для испытания на ударопрочность, вырезаются в направлении, указанном в таблице 6.2 приложения 3, из стенки баллона.
Protect a portion of each test piece from the radiation, and then place the test pieces in the test apparatus 230 mm from and parallel lengthwise to the lamp axis.
Часть каждого испытываемого элемента предохраняется от воздействия излучения, а затем испытываемые элементы помещаются в испытательное приспособление таким образом, чтобы их продольная ось была параллельна оси лампы и находилась от нее на расстоянии 230 мм.
Two test pieces 180 x 25 mm shall be tested with each of the chemicals specified in paragraph 11.1. above, using a new test piece for each test and each cleaning product.
Два испытываемых образца размером 180 х 25 мм подвергаются воздействию каждого из химических веществ, указанных в пункте 11.1 выше, причем для каждого испытания и каждого химического вещества используется новый образец.
The test pieces shall be flat squares of side 100 mm having both surfaces substantially plane and parallel and having a fixing hole 6.4 in diameter drilled in the center, if necessary.
Образцы должны быть плоскими, квадратной формы, со стороной 100 мм; их поверхности должны быть достаточно ровными и параллельными, в центре должно быть просверлено, в случае необходимости, отверстие для крепления диаметром 6,4 мм.
Before each test, test pieces shall be cleaned according to the manufacturer's instructions, then conditioned for 48 hours at a temperature of 23°C ± 2°C and a relative humidity of 50 per cent ± 5 per cent.
Перед каждым испытанием образцы подвергаются промывке в соответствии с указаниями завода-изготовителя, после чего они выдерживаются в течение 48 часов при температуре 23°С ± 2°С на воздухе, относительная влажность которого составляет 50 % ± 5 %.
Keep three samples or three square test pieces of at least 300 x 300 mm in a vertical position for two weeks in a closed container in which the temperature is maintained at 50 ± 2°C and the relative humidity at 95 ± 4 per cent.
Три пробы или три образца квадратной формы размерами не менее 300 х 300 мм выдерживаются в вертикальном положении в течение двух недель в закрытой камере, где поддерживается температура 50°С ± 2°С и относительная влажность 95°С ± 4 %.
NOTE 2: The permanent elongation at fracture is measured by means of test pieces of circular section in which the gauge length l is equal to five times the diameter d (l = 5d); if test-pieces of rectangular section are used the gauge length shall be calculated by the formula:
ПРИМЕЧАНИЕ 2: Остаточное удлинение при разрыве измеряется на образцах круглого сечения, на которых расстояние между метками l в пять раз превышает диаметр d (l = 5d); в случае использования образцов прямоугольного сечения расстояние между метками рассчитывается по формуле:
Examples of word usage in different contexts are provided solely for linguistic purposes, i.e. to study word usage in a sentence in one language and how they can be translated into another. All samples are automatically collected from a variety of publicly available open sources using bilingual search technologies.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.
In this section, you can see how words and expressions are used in different contexts using examples of translations made by professionals. The Contexts section will help you learn English, German, Spanish and other languages. Here you can find examples with phrasal verbs and idioms in texts that vary in style and theme. Examples can be sorted by translations and topics.
Learn foreign languages, see the translation of millions of words and expressions, and use them in your e-mail communication.
Advert