Sentence examples of "испытательный блок" in Russian with translation "test block"
Translations:
all10
test block10
Системы перегородок, за которыми нельзя установить испытательный блок типа 2, этому испытанию не подвергаются.
Partitioning systems behind which the type 2 test block cannot be installed are exempted from this test.
Испытательный блок типа 2 помещается на высоком испытательном полу таким образом, чтобы его наибольшая поверхность площадью 500 х 350 мм была расположена в центре относительно продольной оси транспортного средства, а его поверхность площадью 500 х 125 мм была обращена вперед.
A type 2 test block is placed on the raised test floor with its largest surface 500 x 350 mm, centrally in relation to the longitudinal axis of the vehicle and with its surface 500 x 125 mm to the front.
за исключением фаз обратного движения испытательных блоков.
excluding the rebound phases of the test blocks.
1: Расположение испытательных блоков перед испытанием спинок задних сидений
Figure 1: Positions of test blocks before test of rear seat-backs
В ходе испытания, описанного в приложении 9, испытательные блоки должны оставаться позади спинки (спинок) данного сиденья (сидений).
During the test described in annex 9, the test blocks shall remain behind the seat-back (s) in question.
Расстояние между продольной средней плоскостью жесткой рамы и обращенной внутрь поверхностью каждого испытательного блока должно составлять 25 мм, с тем чтобы блоки находились на расстоянии 50 мм друг от друга. См.
The distance between the longitudinal median plane of the rigid frame and the inward facing side of each test block shall be 25 mm to obtain a distance of 50 mm between both test blocks.
После установки испытательных блоков в положение, описанное в пункте 2.1 или 2.2, кузову легкового автомобиля сообщается ускорение таким образом, как это показано в добавлении к приложению 9, с тем чтобы в момент удара его скорость свободного хода составляла 50 + 0/-2 км/ч.
After the installation of the test blocks as described in paragraph 2.1. or 2.2., the passenger car body shall be accelerated as shown in annex 9, appendix, so that at the moment of impact, its free running speed is 50 + 0/-2 km/h.
Один из испытательных блоков типа 2 устанавливается на приподнятой испытательной панели, причем наибольшая поверхность (500 мм х 350 мм) должна быть обращена к несущей поверхности и располагаться по центру относительно продольной оси жесткой рамы, а поверхность 500 мм х 125 мм должна быть обращена вперед и непосредственно соприкасаться с системой перегородки.
A type 2 test block is to be placed on the raised test floor with its largest surface (500 mm x 350 mm) on the load surface centrally in relationship to the longitudinal axis of the rigid frame and with its surface 500 mm x 125 mm to the front and in direct contact with the partitioning system.
После установки испытательных блоков в положение, описанное в пункте 2.1 или 2.2, кузову легкового автомобиля сообщается замедление или, по выбору подателя заявки, ускорение таким образом, чтобы кривая не выходила за пределы графика, приведенного в добавлении к приложению 9, и общее изменение скорости ?V составляло 50 + 0/-2 км/ч.
After the installation of the test blocks as described in paragraph 2.1. or 2.2., the passenger car body shall be decelerated or, at the choice of the applicant, accelerated such that the curve remains within the area of the graph in Annex 9, Appendix, and the total velocity change ΔV is 50 + 0/-2 km/h.
чертеж с указанием намечаемой схемы (намечаемых схем) установки системы перегородки на типе (типах) транспортных средств и положения (положений) установки системы перегородки, а также достаточных размеров для облегчения установки испытательных блоков, точек крепления к структуре транспортного средства, промежуточных структур, сидений и панелей внутренней отделки, которые могут быть предусмотрены согласно пункту 2 приложения 3;
a drawing of the intended partitioning system installation (s) in vehicle type (s) and partitioning system installation position (s) including sufficient dimensions to facilitate the positioning of the test blocks, anchorage points to the vehicle structure, intermediate structures, seats and trim panels as may be required in Annex 3, paragraph 2.
Examples of word usage in different contexts are provided solely for linguistic purposes, i.e. to study word usage in a sentence in one language and how they can be translated into another. All samples are automatically collected from a variety of publicly available open sources using bilingual search technologies.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.
In this section, you can see how words and expressions are used in different contexts using examples of translations made by professionals. The Contexts section will help you learn English, German, Spanish and other languages. Here you can find examples with phrasal verbs and idioms in texts that vary in style and theme. Examples can be sorted by translations and topics.
Learn foreign languages, see the translation of millions of words and expressions, and use them in your e-mail communication.
Advert