Sentence examples of "удлинение" in Russian with translation "elongation"
Плоский лоб, удлинение теменной и затылочной областей.
Flat forehead, elongation of the parietal and occipital regions.
относительное удлинение в момент разрыва- не менее 50 %.
elongation at break not less than 50 per cent.
относительное удлинение в момент разрыва- не менее 100 %.
elongation at break not less than 100 per cent.
A0 = 27 (минимальное удлинение при разрыве для эталонной стали);
Ao = 27 (minimum elongation for reference steel);
Для сплавов алюминия удлинение при разрыве должно быть не менее 12 %.
For aluminium alloys the elongation at fracture shall be not less than 12 %.
где: A0 = минимальное относительное удлинение (в %) используемой стандартной стали при разрушении под разрывным усилием;
where: Ao = minimum elongation (as a percentage) of the reference steel to be used on fracture under tensile stress;
Прочность на растяжение- не менее 10 МПа и относительное удлинение на разрыв- не менее 250 %.
Tensile strength not less than 10 MPa and elongation at break not less than 250 per cent.
Прочность на разрыв при растяжении и критическое удлинение определяются в соответствии с пунктом A.22 (добавление A).
The tensile yield strength and ultimate elongation shall be determined in accordance with paragraph A.22 (Appendix A).
Прочность на растяжение должна составлять не менее 20 МПа, а относительное удлинение в момент разрыва- не менее 200 %.
Tensile strength not less than 20 MPa and elongation at break not less than 200 per cent.
Прочность на растяжение должна составлять не менее 20 МПа, а относительное удлинение в момент разрыва- не менее 250 %.
Tensile strength not less than 20 MPa and elongation at break not less than 250 per cent.
Прочность на растяжение должна составлять не менее 10 МПа, а относительное удлинение в момент разрыва- не менее 250 %.
Tensile strength not less than 10 MPa and elongation at break not less than 250 per cent.
прочность на растяжение, относительное удлинение при разрыве и модули упругости в соответствии с стандартом EN 61: 1977 в направлении действия напряжений.
Tensile strength, elongation at fracture and modulus of elasticity according to EN 61: 1977 in the direction of stresses.
предел прочности на разрыв, удлинение при разрыве и модули упругости в соответствии со стандартом EN ISO 527-5: 1997 в направлении действия нагрузок.
Tensile strength, elongation at fracture and modulus of elasticity according to EN ISO 527-5: 1997 in the direction of stresses.
процентное удлинение после разлома (А): постоянное увеличение расстояния между контрольными точками после разлома (Lu- Lo), выраженное в виде процента от изначального расстояния между контрольными точками (Lo),
percentage elongation after fracture (A): Permanent elongation of the gauge length after fracture (Lu- Lo), expressed as a percentage of the original length (Lo).
Предел текучести при растяжении и конечное удлинение пластмассового корпуса должны определяться при температуре-50°C с использованием метода ISO 3628 и удовлетворять требованиям пункта 6.3.6 приложения 3.
The tensile yield strength and ultimate elongation of plastic liner material shall be determined at-50°C using ISO 3628, and meet the requirements of paragraph 6.3.6. of Annex 3.
ПРИМЕЧАНИЕ 2: Остаточное удлинение при разрыве измеряется на образцах круглого сечения, на которых расстояние между метками l в пять раз превышает диаметр d (l = 5d); в случае использования образцов прямоугольного сечения расстояние между метками рассчитывается по формуле:
NOTE 2: The permanent elongation at fracture is measured by means of test pieces of circular section in which the gauge length l is equal to five times the diameter d (l = 5d); if test-pieces of rectangular section are used the gauge length shall be calculated by the formula:
A = коэффициент удлинения (в процентах) основного материала;
A = elongation value (per cent) of parent material;
Examples of word usage in different contexts are provided solely for linguistic purposes, i.e. to study word usage in a sentence in one language and how they can be translated into another. All samples are automatically collected from a variety of publicly available open sources using bilingual search technologies.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.
In this section, you can see how words and expressions are used in different contexts using examples of translations made by professionals. The Contexts section will help you learn English, German, Spanish and other languages. Here you can find examples with phrasal verbs and idioms in texts that vary in style and theme. Examples can be sorted by translations and topics.
Learn foreign languages, see the translation of millions of words and expressions, and use them in your e-mail communication.
Advert