Beispiele für die Verwendung von "Planes" im Englischen mit Übersetzung "плоскость"
Between two vertical longitudinal planes passing at 85 mm on either side of the reference line.
между двумя вертикальными продольными плоскостями, проходящими на расстоянии 85 мм с каждой стороны от исходной линии.
in height, by two horizontal planes 1 m and 2.2 m respectively above the ground;
по высоте- двумя горизонтальными плоскостями соответственно на расстоянии 1 м и 2,2 м от поверхности земли;
in height, by two horizontal planes 1 m and 3.0 m respectively above the ground,
по высоте: двумя горизонтальными плоскостями, находящимися на расстоянии 1 м и 3,0 м от поверхности земли, соответственно,
by longitudinal vertical planes 200 mm either side of the median vertical plane of the seating position, and
продольными вертикальными плоскостями на расстоянии 200 мм с обеих сторон средней вертикальной плоскости сидячего положения; и
The head of the manikin shall not pass the planes FD, FG and DE, as shown in Figure 4 below.
Голова манекена не должна выходить за пределы плоскостей FD, FG и DE, показанных на рисунке 4 ниже.
The filament position is checked in two mutually perpendicular planes, one of them being the plane through the lead-in wires.
Положение нити накала контролируется в двух взаимноперпендикулярных плоскостях, в одной из которых расположены подводящие провода нити накала.
1/Maximum lateral deviation of filament centre from two mutually perpendicular planes both containing the reference axis and one containing axis X-X.
1/Максимальное боковое отклонение центра нити накала относительно двух взаимно перпендикулярных плоскостей, которые проходят через ось отсчета и одна из которых проходит через ось X-X.
2/Maximum lateral deviation of filament centre from two mutually perpendicular planes both containing the reference axis and one containing axis X-X.
2/Максимальное боковое отклонение центра нити накала относительно двух взаимно перпендикулярных плоскостей, проходящих через ось отсчета, одна из которых проходит через ось X-X.
1/Maximum lateral deviation of filament centre from two mutually perpendicular planes both containing the reference axis and one containing the axis of the pins.
1/Максимальное боковое отклонение центра нити накала относительно двух взаимно перпендикулярных плоскостей, которые проходят через ось отсчета и одна из которых проходит через ось цокольных штифтов.
During 2002, voluntary head movements in the pitch, yaw and roll planes of one cosmonaut were analysed before, during and after a short space flight.
В течение 2002 года проводились исследования произвольных движений головы космонавта в плоскостях тангажа, рысканья и крена до, в ходе и после кратковременного полета в космосе.
1/Maximum lateral deviation of filament centre from two mutually perpendicular planes both containing the reference axis and one containing the axis of the reference pin.
1 Максимальное боковое отклонение центра нити накала относительно двух взаимно перпендикулярных плоскостей, которые проходят через ось отсчета и одна из которых проходит через ось контрольного штифта.
2/Maximum lateral deviation of filament centre from two mutually perpendicular planes both containing the reference axis and one containing the axis through the reference keys.
2/Максимальное боковое отклонение центра нити накала относительно двух взаимно перпендикулярных плоскостей, которые проходят через ось отсчета и одна из которых проходит через ось контрольных выступов.
2/Maximum lateral deviation of filament centre from two mutually perpendicular planes both containing the reference axis and one containing the axis of the reference pin.
2/Максимальное боковое отклонение центра нити накала относительно двух взаимно перпендикулярных плоскостей, которые проходят через ось отсчета и одна из которых проходит через ось контрольного штифта.
Classroom experiments make use of simple laboratory devices: inclined planes, pulleys, springs, simple pendulums, but the rules that are revealed have validity out in the real world.
Для экспериментов в классе используются простые лабораторные принадлежности: наклонные плоскости, ролики, пружины, математические маятники, но выявляемые с их помощью правила важны и в реальной жизни.
2/Maximum lateral deviation of the major filament centre from two mutually perpendicular planes both containing the reference axis and one containing the axis of the reference pin.
2/Максимальное боковое отклонение центра основной нити накала относительно двух взаимно перпендикулярных плоскостей, которые проходят через ось отсчета и одна из которых проходит через ось контрольного штифта.
There are lines in front of the one on the right, and there are lines behind the one on the left, and so it takes it into different planes.
Есть линии, перед кругом справа, и есть линии, позади круга слева, и таким образом, это они создают разные плоскости.
2/Maximum lateral deviation of the major (high wattage) filament centre from two mutually perpendicular planes both containing the reference axis and one containing the axis through the reference keys.
2/Максимальное боковое отклонение центра основной (с высокой номинальной мощностью) нити накала относительно двух взаимно перпендикулярных плоскостей, которые проходят через ось отсчета и одна из которых проходит через ось контрольных направляющих ключей.
" 7.1.4.4.1.1. Forward facing child restraints: the head of the manikin shall not pass beyond the planes BA and DA as defined in Figure 1 below.
" 7.1.4.4.1.1 Детские удерживающие устройства, обращенные вперед: голова манекена не должна выходить за пределы плоскостей BА и DА, показанных на рисунке 1 ниже.
2/Maximum lateral deviation of the major (high wattage) filament centre from two mutually perpendicular planes both containing the reference axis and one containing the axis of the reference pin.
2/Максимальное боковое отклонение центра основной (с высокой номинальной мощностью) нити накала относительно двух взаимно перпендикулярных плоскостей, которые проходят через ось отсчета и одна из которых проходит через ось контрольного штифта.
Beispiele für den Wortgebrauch in verschiedenen Kontexten werden ausschließlich zu linguistischen Zwecken bereitgestellt, d. h. um den Wortgebrauch in einer Sprache und Varianten ihrer Übersetzung in eine andere zu untersuchen. Alle Beispiele werden automatisch aus offenen Quellen mit Hilfe einer zweisprachigen Suchtechnologie gesammelt. Wenn Sie einen Rechtschreib-, Zeichensetzungs- oder anderen Fehler im Original oder in der Übersetzung finden, nutzen Sie die Option „Problem melden“ oder schreiben Sie uns.
In diesem Abschnitt können Sie anhand professioneller Übersetzungen sehen, wie einzelne Wörter und Ausdrücke in verschiedenen Kontexten verwendet werden. Kontexte helfen Ihnen, Englisch, Deutsch, Französisch, Spanisch und andere Sprachen zu lernen. Hier finden Sie Beispiele mit Phrasal verbs im Englischen, idiomatischen Ausdrücken und mehrdeutigen Wörtern in einer Vielzahl von Stilen und Themen. Die Beispiele können nach Übersetzung und Themen sortiert werden, und anhand der gefundenen Beispiele kann eine Verfeinerungssuche durchgeführt werden.
Lernen Sie Fremdsprachen und prüfen Sie Verwendung von Wörtern an realen zweisprachigen Beispielen.
Werbung