Traduction de "brake cooling" en russe
Résultat de la traduction
Votre texte a été partiellement traduit.
Vous ne pouvez pas traduire plus de 999 caractères à la fois.
Connectez-vous ou inscrivez-vous gratuitement sur PROMT.One et traduisez encore plus !
La publicité
Traductions du dictionnaire pour "brake cooling"
brake cooling
nom
Contextes avec "brake cooling"
Time to try out my water brake cooling system.
Время опробовать мою водяную систему охлаждения тормозов.
It's the water tank for the brake cooling system.
Эта цистерна с водой для системы охлаждения тормозов.
Brakes equipped with automatic brake adjustment devices shall, after heating followed by cooling, be capable of free running as defined in paragraph 1.7.3. of Annex 4 following the Type-I or Type-III test also defined in that annex as appropriate.
Тормоза, оснащенные системами автоматического регулирования, должны быть пригодными при нагреве и последующем охлаждении для обеспечения свободного хода, определение которого приведено в пункте 1.7.3 приложения 4, после испытаний типа I или типа III, определения которых также приведены в этом приложении.
Brakes equipped with automatic brake adjustment devices shall, after heating followed by cooling, be capable of free running as defined in paragraph 1.5.4. of Annex 4 following the Type-I test also defined in that annex.
Тормоза, оснащенные системой автоматического регулирования, должны быть пригодными при нагреве и последующем охлаждении для обеспечения свободного хода, определение которого приведено в пункте 1.5.4 приложения 4, после испытания типа I, определение которого также приведено в этом приложении.
Therefore, in order to minimize non-representative test results, a recommendation was made that the ESC test procedures should specify a minimum of 90 seconds between test runs in order to allow sufficient time for cooling of the brake pads.
В этой связи для сведения к минимуму нерепрезентативных результатов испытаний была вынесена рекомендация предусмотреть в процедурах испытания ЭКУ перерыв между испытательными прогонами продолжительностью не менее 90 с- время, достаточное для того, чтобы тормозные колодки остыли.
Les exemples sont fournis uniquement à des fins linguistiques, c'est-à-dire pour étudier l'utilisation de mots dans une langue et leurs traductions dans une autre. Ils sont extraits automatiquement des sources ouvertes en utilisant des algorithmes de recherche de données bilingues. Si vous trouvez une erreur d'orthographe, de ponctuation ou autre soit dans l'original ou dans la traduction, utilisez l'option "Signaler un problème" ou écrivez-nous.
La publicité