Traduction de "horizontal beam width" en russe

Texte source

Résultat de la traduction

Votre texte a été partiellement traduit.
Vous ne pouvez pas traduire plus de 999 caractères à la fois.
Connectez-vous ou inscrivez-vous gratuitement sur PROMT.One et traduisez encore plus !

<>

La publicité

Traductions du dictionnaire pour "horizontal beam width"

horizontal beam width nom
pl. horizontal beam widths

Contextes avec "horizontal beam width"

I've reduced the beam to the width of a knitting needle. Я доводил лучевой шнур до толщины вязальной спицы.
After horizontal adjustment of the front fog beam according to paragraph 3.1., the vertical adjustment shall be performed in such a way that the cut-off line is moved upwards from the lower position until it is situated on the v-v line at 1°below the h-h line. После горизонтальной корректировки пучка света передней противотуманной фары в соответствии с пунктом 3.1 производится его вертикальная корректировка таким образом, чтобы светотеневая граница перемещалась вверх от нижнего положения до тех пор, пока она не будет установлена по линии v-v на 1°ниже линии h-h.
Where a headlamp so aimed does not meet the requirements set out in paragraphs 6.2.5., 6.2.6. and 6.3., its alignment may be changed, except for headlamps that have no mechanism to adjust horizontal aim, on condition that the axis of the beam is not displaced laterally by more than 1 degree (= 44 cm) to the right or left/. Если фара, направленная таким образом, не отвечает предписаниям, изложенным в пунктах 6.2.5, 6.2.6 и 6.3, то ее регулировка может быть изменена, за исключением фар, у которых нет механизма для корректировки горизонтального направления, при условии что ось луча не смещена по горизонтали более чем на 1 градус (= 44 см) вправо или влево/.
Vertical adjustment: After horizontal adjustment of the symmetrical passing-beam headlamp according to paragraph 3.1. above, the vertical adjustment shall be performed in such a way that the beam with its cut-off line is moved upwards from the lower position until the cut-off line is situated at nominal vertical position. Вертикальная корректировка: после горизонтальной корректировки симметричного пучка ближнего света в соответствии с пунктом 3.1, выше, производится его вертикальная корректировка таким образом, чтобы пучок с его светотеневой границей передвигался вверх от нижнего положения до тех пор, пока светотеневая граница не будет установлена в номинальное вертикальное положение.
New attribute horclw (Horizontal clearance, width) duplicates S-57 attribute HORWID by definition. Новый атрибут horclw (Ширина горизонтального клиренса) дублирует атрибут S-57 HORWID по определению.
Plus en détails
Les exemples sont fournis uniquement à des fins linguistiques, c'est-à-dire pour étudier l'utilisation de mots dans une langue et leurs traductions dans une autre. Ils sont extraits automatiquement des sources ouvertes en utilisant des algorithmes de recherche de données bilingues. Si vous trouvez une erreur d'orthographe, de ponctuation ou autre soit dans l'original ou dans la traduction, utilisez l'option "Signaler un problème" ou écrivez-nous.

TÉLÉCHARGEZ L'APPLICATION MOBILE PROMT.ONE

Télécharger dans l'App Store - PROMT.OneTélécharger dans l'App Store - PROMT.One Disponible sur Google Play - PROMT.OneDisponible sur Google Play - PROMT.One Découvrez sur App Gallery – PROMT.OneDécouvrez sur App Gallery – PROMT.One