Translation of "circular section" to Russian
Translation results
Your text has been partially translated.
You can translate a maximum of 5000 characters at a time.
Advert
Dictionary translations for "circular section"
circular section
noun
pl.
circular sections
Contexts with "circular section"
The bar shall be of solid mild steel of circular section, (15.0 ± 0.5) cm in diameter and 20 cm long unless a longer bar would cause greater damage, in which case a bar of sufficient length to cause maximum damage shall be used.
Штырь должен быть изготовлен из мягкой стали и иметь круглое сечение диаметром (15,0 ± 0,5) см и длину 20 см, если только при большей длине штыря не будет наноситься более сильное повреждение; в этом случае должен использоваться штырь достаточной длины для нанесения максимального повреждения.
NOTE 2: The permanent elongation at fracture is measured by means of test pieces of circular section in which the gauge length l is equal to five times the diameter d (l = 5d); if test-pieces of rectangular section are used the gauge length shall be calculated by the formula:
ПРИМЕЧАНИЕ 2: Остаточное удлинение при разрыве измеряется на образцах круглого сечения, на которых расстояние между метками l в пять раз превышает диаметр d (l = 5d); в случае использования образцов прямоугольного сечения расстояние между метками рассчитывается по формуле:
When measuring the luminances from measuring direction B as defined on sheet DxR/7 with a set-up as outlined in Annex 5, however with a circular field of 0.2M mm diameter, the relative luminance expressed as a percentage of L max (at cross section D) shall be:
При измерении величин яркости в направлении измерения B, которое определяется спецификацией DхR/7 в соответствии со схемой, указанной в приложении 5, но во вращающемся поле с диаметром 0,2М мм, относительная яркость, выраженная в процентах от Lmax (в поперечном сечении D), должна составлять:
When measuring the luminances from measuring direction B as defined on sheet D1R/D2R/6 with a set-up as outlined in Annex 5, however with a circular field of 0.2M mm diameter., the relative luminance expressed as a percentage of L max (at cross section D) shall be:
При измерении величин яркости в направлении измерения B, которое определяется спецификацией D1R/D2R/6 в соответствии со схемой, указанной в приложении 5, но во вращающемся поле с диаметром 0,2М мм, относительная яркость, выраженная в процентах от Lmax (в поперечном сечении D), должна составлять:
Examples of word usage in different contexts are provided solely for linguistic purposes, i.e. to study word usage in a sentence in one language and how they can be translated into another. All samples are automatically collected from a variety of publicly available open sources using bilingual search technologies.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.
If you find a spelling, punctuation or any other error in the original or translation, use the "Report a problem" option or write to us.
Testimonials
Advert